Dock System Outside Corner (Female)

Dock System Hardware Outside Crnr Female
Tie Down dock hardware is designed for use with 1-1/2" thick lumber (minimum width 6"). All hardware is mounted with carriage bolt...

Cellofoam North America Permafloat Dock System Outside Corner Male
The outside corner male is used with outside corner females or female "T" connectors. It is only used on dock corners. It has two ...

Dock Assembly System J) Outside Corner, Female by Tiedown Engineering
We offer a complete line of rugged dock hardware for building a dock at your summer cabin or waterfront home. Designed primarily f...

Dock System Hardware Outside Corner End
Tie Down dock hardware is designed for use with 1-1/2" thick lumber (minimum width 6"). All hardware is mounted with carriage bolt...

Dock System Hardware Inside Corner
Tie Down dock hardware is designed for use with 1-1/2" thick lumber (minimum width 6"). All hardware is mounted with carriage bolt...

Cellofoam North America Permafloat Dock System Hardware Female T Connector
The single "T" female bolts to the side of a dock where a finger or ramp may attach or where an outside corner female can't be use...

Outside Corner (Male) (Standard Grade) By Tie Down

Dock System Hardware 3" Pipe Holder
Tie Down dock hardware is designed for use with 1-1/2" thick lumber (minimum width 6"). All hardware is mounted with carriage bolt...

Dock System Hardware Washer Plate
Tie Down dock hardware is designed for use with 1-1/2" thick lumber (minimum width 6"). All hardware is mounted with carriage bolt...

Dock System Hardware Male T Connector
Tie Down dock hardware is designed for use with 1-1/2" thick lumber (minimum width 6"). All hardware is mounted with carriage bolt...

Dock System Hardware Connector Pin Set
Tie Down dock hardware is designed for use with 1-1/2" thick lumber (minimum width 6"). All hardware is mounted with carriage bolt...

Tie Down Inside Corner Pipe Holder 3" Od Insde
These heavy-duty inside corners should be used with one of the outside corners and as an internal pipe holder to be used with eit...

Angle 2.5"L X 5"H Legs
Use this heavy-duty angle for all cross supports. Each Leg measures 2 1/2"L X 5"HStandard Grade P/N 26527Sh. Wt. 4 lbs.

Back Up Plate 5" X 5"
Q- 5"X5" reinforcing plates are used to back up the Single T Males and Females. Commercial Grade P/N 26413 Sh. Wt. 4 lbs.

Female T Connector 5" X 5"
Has two welded 1/2" tabs. Bolts to side of dock to attach fingers and ramps. 5"H X 5"L.Standard Grade P/N 26528Sh. Wt.5 lbs.